Форум системных администраторов
IT => Windows => MS Exchange => Тема начата: Triangle от 14 января 2013, 13:27:05
-
Ошибка при выполнении команды "test-MapiConnectivity" Область: Mailbox Server Role Health
Ошибка при выполнении команды "test-MapiConnectivity -Server MAIL -PerConnectionTimeout 120". Сообщение об ошибке: Параметр StorageGroup недопустим..
Exchange 2010 почта не уходит на очень разные адреса, проверял их доступность, доступны.
-
Triangle, посмотри логи, в логах ничего плохого нет?
Updated: 14 January 2013, 14:30:05
Ошибка при выполнении команды "test-MapiConnectivity -Server MAIL -PerConnectionTimeout 120". Сообщение об ошибке: Параметр StorageGroup недопустим..
Это полный вывод команды?
-
Это было из анализатора дал из консоли вообще всё чисто :(
[PS] C:\Windows\system32>test-MapiConnectivity -Server MAIL -PerConnectionTimeout 120
MailboxServer Database Result Error
------------- -------- ------ -----
MAIL Mailbox Databas... Удачно...
[PS] C:\Windows\system32>
-
Ну это полный вывод из анализатора?
-
Первое сообщение да, и если смотрю в очередь вижу что нихрена не уходит.
Вторая ошибка анализатора
Удаленный сервер MAIL не прошел проверку приема почты при попытке открытия удаленного сокета: Respond = Remote socket is not available.
-
Там по-русски что ли все? Если да, значит переводить и пытаться гуглить ошибки. Русский на сервере - :bee:
-
Причина неотправки
Attempted failover to alternate host, but that did not succeed. Either there are no alternate hosts, or delivery failed to all alternate hosts”.
гуглю
Updated: 14 January 2013, 16:46:40
http://support.microsoft.com/kb/979175/en
Start Exchange Management Console.
Expand Server Configuration and then click Hub Transport.
Click the Receive Connectors tab.
Locate the remote Exchange server receive connector that the e-mail message is trying to be sent to.
Note To determine this, you can review the send protocol logs from the server that the e-mail message is stuck in.
Right-click the receive connector and then click Properties.
NoteThis is typically the Default server_name receive connector for the remote Exchange server, unless modifications were made. If you are not sure which connector is used, receive protocol logs shows the receive connector that is used.
On the Authentication tab, make sure that the Exchange Server authentication check box is selected.
А теперь вопрос, у меня два коннектора, где в логах смотреть какой был задействован.
Updated: 14 January 2013, 18:51:47
Заметил что чаcть ошибок пересылки связана с DNS. Указал на Hub Transport Server внешние DNS в явном виде для внешних запросов, ранее был указан интерфейс, который по сути внутри. Но работало же блин.